Connection To A Tv (For Video) - Clatronic DVD 658 HC Bedienungsanleitung

• Do not expose the remote sensor to direct light from
the sun or lighting apparatus. Doing so may cause a
malfunction in controlling the player.
• If you do not use the remote control unit for an extended
period of time, remove the batteries to avoid possible
damage from battery leakage and corrosion.
Range of Operation of the Remote Control
The remote control can be used up to approximately 5
meters in a straight line.
It can also be operated at a horizontal angle of up to 30°
from the remote sensor.
Front Panel (for Subwoofer)
1. Virtual Sound ON / OFF selector
2. Standby indicator
30
English.p65 30
Back Panel
(for Subwoofer)

CONNECTION TO A TV (FOR VIDEO)

METHOD 1 DVD Player + TV with Video input jack
METHOD 2 DVD Player + TV with S-Video input jack
METHOD 3 DVD Player + TV with Component input jack
NOTE: Connect ONE of the above options ONLY, to avoid
picture interference.
1. The player is equipped with composite A/V outputs at
the rear of the player. your TV will require at least one
set of A/V inputs. The patch cord supplied with the
player will connect your player's A/V output to your
TV's inputs.
2. Please remember to push the "Line" or "Input" or "Video/
TV" button on your TV remote to view the DVD signal.
Depending on your brand of TV, this button will have
a different name for the same function, as per the
examples above.That function will allow the TV to be
switched from broadcast reception mode to one of the
A/V signals, your TV should have more than one A/V
Input.
3. The player is equipped for stereo playback. To fully
realize 2 channel sound, a Stereo TV or A/V receiver
is necessary. However, a Mono TV may be used
providing the TV one set of A/V Inputs. The A/V inputs
on a Mono TV will only include one Audio Input for
Mono sound. You may connect either the Left or Right
audio channel from the DVD Composite audio out to
the mono TV audio input.
2/2/05, 12:33 PM