Locating And Rectifying Short Circuits In The Equipment; Repairs; Disposal; Spare Parts - Simco Multi Power Master Bedienungsanleitung

10.2. Locating and rectifying short circuits in the equipment

Warning:
- Disconnect the power supply before carrying out work on the unit.
- Equipment and metal-shielded cables must be properly earthed. For this reason, it is
necessary that the glands on the shielded cables are properly fitted. Earthing is
required to ensure proper operation of the equipment and to avoid unpleasant
electrical shocks upon contact
- Disconnect the ionisation equipment from the MPM.
- Check that the [Overload] LED does not light up when the MPM/high voltage is switched on.
- Switch the MPM off again.
- Connect the ionisation units one by one and, after each unit has been connected, check
whether the [Overload] LED lights up when the high voltage is switched on.
- If the [Overload] LED lights up after connecting a unit, the relevant unit is causing the short
circuit.
- Consult the manual for that unit for details of how to rectify the short circuit.

11. Repairs

Warning:
- Disconnect the power supply before carrying out work on the unit.
- Repairs must be carried out by a skilled electrical engineer.
SIMCO (Nederland) B.V. recommends that you return the MPM if repairs are required.
Request an RMA form by sending an e-mail to service@simco-ion.nl.
Pack the MPM properly and clearly state the reason for return.

12. Disposal

Observe the applicable local environmental and other regulations when disposing of the
equipment.

Spare parts

Part number Description
9145110025 Mains switch 1/0
4510140130 I/o connector 12-pole, cable part
6807004160 I/O cable 6m
Spare parts can be obtained from the agent in your region or from SIMCO (Nederland) B.V.
SIMCO (Nederland) B.V.
PO Box 71
7240 AB Lochem, The Netherlands
Telephone +31-(0)573-288333
Fax +31-(0)573-257319
E-mail general@simco-ion.nl
Internet http://www.simco-ion.nl
MPM_UM_9752080610_NL_D_GB_F_V1_5
GB
52