Removal And Storing In The Transport Case - Storch ProCut top Bedienungsanleitung

Cut-outs (complete)
•
•
•
•
•
•
•
Cut-outs
(only possible
with an incision)
Replacing the cutting wire on the corner cutter:
Caution: Use only prefabricated cutting wires (Art. no. 57 33 02) from the device's scope of supply. Before replacing the
wire, switch off the device, disconnect the plug from the power supply, and let the wire cool down for a couple of minutes.
Make sure that the wire runs in the groove on the guide pulley and the attachment pin.

Removal and storing in the transport case

Fold in the base and slot it into the recesses for the device mount (23) on the rear of the ProCut top. Fix the base in place
with the fastening clamp – as shown.
Fig. 10
Mark all the dimensions on the insulating panel.
Position the insulating panel on the bearing rail (8).
Guide the corner cutter (2) down to the point marked for cutting into the panel.
Slide the insulating panel from left to right until you have reached the desired length for
the cut-out.
Push the corner cutter back up again until you have reached the desired height for the
cut-out.
Now slide the insulating panel from the right to the left until you have reached the desi-
red length for the cut-out.
Now guide the corner cutter back to the starting point.
10 Base/Freestanding support
11 Reproducible slider for mitre cuts
23 Mount for base/freestanding support
24 Fastening clamp for base/freestanding support
36 Locking lever for cutting bow
59
Translation of the original instruction