Initial Operation Of Procut Top - Storch ProCut top Bedienungsanleitung

Device description / ProCut top rear view
Fig. 2
Device description - Setup / initial operation of ProCut top:
Transport position
The device is transported and delivered in a plastic case: Open the case and remove the device.
Do not use the cutting bow to lift the device (Pos. 13, Fig. 3) from the case. Fold out the carrying handle (Pos. 27, Fig. 3)
and use it to lift the device. Set up the device in the same way as you remove it from the case, on the rubber feet located
on the long side (Pos. 28, Fig. 3).
Fig. 3
7 Corner slider right support rail
and corner cutter
7a Locking screw for right bearing rail
19 Reproducible slider for mitre cuts
20 Lean-to buffer
21 Fastener for folded-in corner cutter
22 Carrying bag for spare wire (3 x)
and fuse (1 x)
23 Mount for base/freestanding support
24 Fastening clamp for base/freestanding support
25 Fastening bolt for left bearing rail
26 Transformer with cable reel
27 Fold-out carrying handle
28 Corner cutter articulation
10 Base/Freestanding support
13 Cutting bow
24 Fastening clamp for base/freestanding support
27 Fold-out carrying handle
28 Rubber foot
53
Translation of the original instruction