Operation And Use; Connections; Connecting The Lance To The Spray Gun; Connecting The High Pressure Hose And The Water Hose - Storch 225 FUEL Bedienungsanleitung

4. Operation and use

4.1

Connections

4.1.1

Connecting the lance to the spray gun

1. Pull the blue quick-release grip (A) of the spray handle
backwards.
2. Insert the nipple of the spray lance (B) into the quick-
release connection and release it.
3. Pull forward the spray lance or any other accessory to
ensure correct mounting before starting the machine.
NOTE!
Always remove any dirt from the nipple before connecting
the lanse to the spray gun.
4.1.2 Connecting the high pressure hose and the water
hose
1. Connect the high pressure hose to the high pressure
inlet by means of the quick coupling. Use max. 30 m
extension hose.
2. Before connecting the water hose to the washer, rinse
the water hose briefly to prevent sand and other dirt from
entering into the washer.
3. Open the tap.
NOTE!
See chapter Technical data for required quantity of water
and water pressure. In the case of poor water quality
(sand, etc.), we recommend that a fine water filter is fit-
ted in the water inlet.

4.1.3 Fuelling

WARNING!
Always shut off the engine and let it cool for at least two
minutes before fuelling. Avoid spilling fuel. If you do spill
fuel when fuelling, do not start the engine before the spil-
led fuel has evaporated. If the washer is on a trailer, any
fuel spills must be wiped up before the machine is star-
ted.
Never expose the machine to an open flame. Smoking is
prohibited during fuelling. Also read the operating manual
for the fuel engine.
NOTE: Never operate the machine in a closed room;
the exhaust fumes are dangerous.

4.2 Start the washer

4.2.1 Switching on the washer when it is connected to a
water supply
55 Original instruction