Selecting The Operating Mode; Low Battery Indicator - EdilKamin PELLBOX SCF Installations-, Betriebs- Und Wartungsanleitung

TEMPERATURE DETECTED BY THE REMOTE CONTROL
The remote control is equipped with an internal sensor to detect the room temperature and display it in real time.
The detected temperature is transmitted periodically to the control board of the insert/stove if the transmission LED of
the remote control and the receiving sensor of the synoptic panel of the insert/stove are in each other's field of view.
If the temperature of the remote control does not reach the control board of the insert/stove for over 30 minutes, the
temperature detected by the sensor connected to the synoptic panel is used.

SELECTING THE OPERATING MODE

The following functions can be scrolled through and set by briefly pressing the "M" button:
temperature adjustment in automatic mode
manual adjustment of the power
USING THE "EASY TIMER" PROGRAM
The new remote control allows you to manage a new timer program that is very intuitive and easy to use:
- If the insert is on: a delayed shutdown can be set from the remote control - from one to twelve hours. The remai-
ning time for the scheduled shutdown is shown on the display of the synoptic panel.
- If the insert is off: a delayed ignition can be set from the remote control - from one to twelve hours. The remaining
time for the scheduled ignition is shown on the display of the synoptic panel.
- Setting: proceed as follows to set the timer:
a)Press the "A" button and the icon
has been accessed.
b) Set the hours by pressing the +/- buttons, for example:
c) Point the remote control towards the synoptic panel receiver
d) Confirm the setting by pressing the "A" button for a few seconds; the icon
will appear on the synoptic panel after which the "Easy timer" setting will intervene.
e) Repeat points a), b), c), d) to cancel the setting, and set the hours to "00H
BLOCKED KEYPAD
The remote control buttons can be blocked so as to prevent it from going on accidentally.
Press the A and M buttons simultaneously and the key symbol
blocked. Press the A and M buttons simultaneously once again to unblock the keypad.
PROGRAMMING
Proceed as follows to enter the programming menus of the timer, pellet reserve, I/O test, parameters, ADJ pellet, etc.:
- Briefly press any button on the remote control to exit the stand-by mode. The backlight of the buttons lights up when
the remote control is used.
- Press the "M" button for approximately 5 seconds; release the button when the transmission icon
lines will appear on the display (- - -) and this means that the navigation-menu mode has been accessed successfully.
- Press the
button for approximately 1 second to exit the navigation-menu mode.

LOW BATTERY INDICATOR

When the battery icon lights up it indicates that the batteries inside the remote control are almost flat. Replace them
with three new batteries of the same model (size AAA 1.5V).
will light up on the display, thereby confirming the "Easy timer" program
will light up confirming that the keys have been
27
will go off and the remaining time
"
goes on; three