Service Data; Installation - Electrolux EOC5654TAX Benutzerinformation

Problem
The water comes out of
the cavity embossment.
The appliance is activated
and does not heat up. The
fan does not operate. The
display shows "Demo".

12.2 Service data

If you cannot find a solution to the
problem yourself, contact your dealer or
an Authorised Service Centre.
The necessary data for the service
centre is on the rating plate. The rating
We recommend that you write the data here:
Model (MOD.)
Product number (PNC)
Serial number (S.N.)

13. INSTALLATION

WARNING!
Refer to Safety chapters.
Possible cause
There is too much water in
the cavity embossment.
The demo mode is activa‐
ted.
plate is on the front frame of the oven
cavity. Do not remove the rating plate
from the oven cavity.
.........................................
.........................................
.........................................
ENGLISH
Remedy
Deactivate the oven and
make sure that the appli‐
ance is cold. Wipe the wa‐
ter with a cloth or sponge.
Add the correct amount of
water to the cavity em‐
bossment. Refer to the
specific procedure.
1. Deactivate the oven.
2. Press and hold at the
same time
.
3. The first digit on the
display and Demo indi‐
cator start to blink.
4. Enter the code 2468 by
turning the knob for the
temperature right or left
to change the values
and press to con‐
firm.
5. The next digit starts to
blink.
6. Demo mode deacti‐
vates when you con‐
firm the last digit and
the code is correct.
33