Symbols Description - PANCONTROL PAN 188 Bedienungsanleitung

- Do not use the device near strong magnetic fields (for e.g. welding
transformer), as this can distort the display.
- Do not use the device outdoors, in humid surroundings or in
environments that are subjected to extreme temperature fluctuations.
- Do not store the device in places which are exposed to direct sunlight.
- Remove the battery if the device is not used for a long time.
- If changes or modifications are made to the device, the operational
safety is no longer guaranteed and the warranty becomes void.

4. Symbols Description

Conforms to the relevant European Union directive (EN-61010)
Product is protected by double insulation
Risk of Danger. Important information See instruction manual
Attention! Hazardous voltage. Risk of electric shock.
This product should not be disposed along with normal
domestic waste at the end of its service life but should be
handed over at a collection point for recycling electrical and
electronic devices.
CAT III
The device is designed for making measurements in building
installations. Examples are measurements on junction boards,
circuit breakers, wiring, switches, permanently installed
sockets, devices for industrial use as well as permanently
installed motors.
CAT IV
The device is designed for making measurements at sources of
low voltage installations. Examples are meters and
measurements on primary overload protection devices and
ripple control devices.
EN 5