Resistance Measurement - PANCONTROL PAN 188 Bedienungsanleitung

DC Voltage measurement / AC Voltage measurement
Attention!
DC voltage max. 1.000 V
AC voltage max. 750 V
1. Set the rotary switch to the position V or mV
2. Attach the pin-plug of the black test lead to the COM-jack and the
pin-plug of the red test lead to the general jack. (4.3)
3. Connect the black test prod to the negative pole and the red test prod to
the positive pole of the circuit to be tested.
4. Once the reading stabilizes, read the value. If the polarity is twisted a
"Minus sign" is displayed.
DC current / AC Current measurement
Avoid current measurements with the 10A setting for more than 30 seconds.
This can damage the device and / or the test leads.
1. For measurements up to 6000 µA (mA) set the rotary switch to the µA
(mA)-Position and attach the pin-plug of the red test lead to the µA
(mA)-jack. For measurements up to 10 A set the rotary switch to the
A-Position and attach the pin-plug of the red test lead to the A-jack.
2. Connect the black test prod to the negative pole and the red test prod to
the positive pole of the circuit to be tested.
3. Once the reading stabilizes, read the value. If the polarity is twisted a
"Minus sign" is displayed.

Resistance measurement

Before making any measurements, make sure the circuit is disconnected from
any power source and all capacitors are properly discharged!
1. Set the rotary switch to the position
Attach the pin-plug of the black test lead to the COM-jack and the
2.
pin-plug of the red test lead to the general jack. (4.3)
Connect the black test prod to the negative pole and the red test
3.
prod to the positive pole of the circuit to be tested.
Once the reading stabilizes, read the value. If the polarity is twisted a
4.
"Minus sign" is displayed.
Ω
EN 15