Memorization Procedure - tau K126MA Installationsanleitung

2 2 / 4 STROKE
CLOSES AGAIN
3 AFTER THE
PHOTOCELL
4
NO REVERSE
PRE-
5
FLASHING
6 FOTOTEST
MASTER/
7
SLAVE
BACK
8
JUMP
9-10-11 Automation type selection
Dip 9 Dip 10
Off Off
On Off
Off On
On On
Off Off
On Off
Off On
On On
IMPORTANT: In case the automation type change, a new setting of the dips # 9, 10 and
11 will be required. Before the new setup, however, it is necessary to proceed to a HARD
RESET (see pag. 25) of the controller.
SENSITIVE
12
EDGE

MEMORIZATION PROCEDURE

WARNING: After powering the control panel, wait 2 seconds before you start performing the
adjustment operations.
Note: the mechanical stops of the automation must be regulated both in opening and in clos-
ing [see motor instructions].
When you have completed the installation procedures:
Check the position of dip-switches 9, 10 and 11. Dip-switches must be set according to
the automation model (see table of dip-switches 9-10-11, "Logic adjustments" section).
It is recommended to start the learning process with the gate at 0,5 m from closing mechanical stop.
Press without releasing the PROG button till the DL8 LED starts flashing (yellow):
when the automation is operating, a sequence of opening/closing com-
On
mands causes the automation to OPEN-CLOSE-OPEN-CLOSE, etc.
in the same conditions, the same sequence of commands causes the
Off automation to OPEN-STOP-CLOSE-STOP-OPEN-STOP, etc . (step-by
step function) (see also dip switch 4).
after the photocell is activated (input 7 - 9), the automation closes
On
automatically after 5 seconds.
Off function off.
the automation ignores the closure command during opening and
On
auto-close time
Off the automation responds as established by dip switch No. 2.
On the pre-flashing function is enabled.
Off
the pre-flashing function is disabled.
On the "photocell test" function is enabled.
the "photocell test" function is disabled.
Off
Note: to be used when the photocells are not used.
enables the MASTER mode in the master/slave configuration (see T-
On
COMM instructions).
enables the SLAVE mode in the master/slave configuration (see T-
Off
COMM instructions), or standard operation (single motor).
once reached the mechanical stop (either while opening or closing) the
On
operator will reverse slightly to avoid jamming between pinion and rack.
Off function not activated.
Dip 11 Automation
Off
TONE-5B
Off TONE-10B
Off TONE-5BR (24v)
Off MASTER-R (24V Opening speed = Closing speed)
On MASTER18QR
On MASTER-R (24V)
On CANTILEVER (light)
On
CANTILEVER TONE10B (heavy)
On RESISTIVE SENSITIVE EDGE (terminal No. 10).
FIXED EDGE (NC contact – terminal No. 10).
Off
Note: if not used, keep the DIP in the OFF position.
K126MA 21