Battery Removal/Installation - Hitachi WH 12DC Bedienungsanleitung

3. Wood working drill bit: Code No. 959183
4. Drill chuck adapter set: Code No. 996195
Use the drill available on the market.
5. Holster: Code No. 307824
Use the holster to hold the unit during its operation.
Carefully read the warnings attached to the holster
for safe use.
6. Hook: Code No. 308090
Use the hook to hold the unit during its operation.
Carefully read the instructions that come with the
hook to learn how to use it.
Optional accessories are subject to change without
notice.
Table 1
Before charging
While charging
Charging complete
Charging impossible
APPLICATION

BATTERY REMOVAL/INSTALLATION

1. Battery removal
2. Battery installation
CHARGING
Before using the impact driver charge the battery as
follows.
1. Connect the charger's power cord to an AC outlet.
2. Insert the battery into the charger.
3. Disconnect the charger's power cord from the AC
4. Hold the charger firmly and pull out the battery.
CAUTIONS
Indications of the pilot lamp
Blinks Lights for 0.5 seconds. Does not lights for 0.5 seconds.
(off for 0.5 seconds)
Lights Lights continuously
Blinks Lights for 0.5 seconds. Does not lights for 0.5 seconds.
(off for 0.5 seconds)
Blinks Lights for 0.1 seconds. Does not lights for 0.1 seconds.
(off for 0.1 seconds)
Driving and removing of small screws, small bolts,
etc.
Hold the hadle tightly and push the battery latch
to remove the battery. (Fig. 2)
Insert the rechargeable battery, making sure that the
latch is on the trigger switch side of the handle.
(Fig. 2)
When the power cord is connected, the charger's
pilot lamp will blink slowly. (At 1-second intervals.)
Position the battery so that the nameplate faces
toward the ventilation slots of the charger and push
in the battery until it contacts the bottom plate. (See
Figs. 1 and 3.)
When the rechargeable battery is connected to the
charger, charging will commence and the pilot lamp
will light on. It takes about an hour to fully charge
the battery at a temperature of around 209C.
When the battery is fully charged, the pilot lamp
will blink slowly. (At 1-second intervals.) (See Table
1.)
outlet.
If the battery has been heated (due to sunlight, etc.)
right after operation, the charger's pilot lamp may
not light on. In such a case, first let the battery cool,
then start charging.
If the pilot lamp blinks quickly (at 0.2-second inter-
vals), check for and take out any foreign objects in
the charger's battery installation hole. If there are
no foreign objects, it is probable that the battery
or charger is malfunctioning. Take it to your author-
ized Service Agent.
English
5