Battery Removal/Installation; Prior To Operation - Hitachi WH 8DC2 Bedienungsanleitung

3. Wood working drill bit: Code No. 959183
4. Drill chuck adaptor set: Code No. 996195
Use the drill available on the market.
APPLICATION
Driving and removing of small screws, small bolts,
etc.
Table 1
Blinks
Before
charging (RED)
Lights
While
charging (RED)
Charging Blinks
complete (RED)
Charging Flickers
impossible (RED)
Lights
Charging
(GREEN)
impossible
3. Disconnect the charger's power cord from the AC
outlet.
4. Hold the charger firmly and pull out the battery.
CAUTIONS
If the battery has been heated right after operation
(or due to sunlight, etc.), the charger's pilot lamp
may not light in red. In such a case, first let the
battery cool, then start charging.
When the pilot lamp flickers in red quickly (at 0.2-
second intervals), check for and take out any foreign
objects in the charger's battery installation hole. If
there are no foreign objects, it is probable that the
83
Indications of the pilot lamp
Lights for 0.5 seconds. Does not light for 0.5
seconds. (off for 0.5 seconds)
Lights continuously
Lights for 0.5 seconds. Does not light for 0.5
seconds. (off for 0.5 seconds)
Lights for 0.1 seconds. Does not light for 0.1
seconds. (off for 0.1 seconds)
Lights continuously

BATTERY REMOVAL/INSTALLATION

1. Battery removal
Hold the hadle tightly and push the battery latch
to remove the battery. (Fig. 2)
2. Battery installation
Insert the rechargeable battery, making sure that
the latch is on the trigger switch side of the handle.
(Fig. 2)
CHARGING
Before using the impact driver charge the battery as
follows.
1. Connect the charger's power cord to an AC outlet.
When the power cord is connected, the charger's
pilot lamp will blink in red. (At 1-second intervals).
2. Insert the battery into the charger.
Position the battery so that the nameplate faces
toward the caution plate of the charger and push
in the battery until it contacts the bottom plate. (See
Figs. 1 and 3.)
When inserting a battery in the charger, charging
will commence and the pilot lamp will light con-
tinuously in red. It takes about 45 minutes to fully
charge the battery at a temperature of around 20°C.
When the battery becomes fully recharged, the pilot
lamp will blink in red. (At 1-second intervals.) (See
Table 1)
battery or charger is malfunctioning. Take it to your
authorized Service Agent.

PRIOR TO OPERATION

1. Preparing and checking the work environment
Make sure that the work site meets all the conditions
laid forth in the precautions.
2. Checking the battery
Make sure that the battery is installed firmly. If it
is at all loose it can fall off and cause an accident.
English
Malfunction in the
battery or the charger
The battery tempera-
ture is high, making
recharging impossible.
5