Advanced Setting Menu (Infrared) - Videotec ULISSE Bedienungsanleitung

10.1.8.10 Advanced Setting Menu (Infrared)

It allows you to configure the following parameters:
1. IR Probe: Signals the presence of a probe to
manage the switching of the motorised lens
from the Day to the Night mode. The following
modes are selectable:
• Off: Signals that none of the operative modes
designed to manage the LED illuminators is
active.
• External: The reference probe for switching
between the two operative modes is the
daylight sensor connected to the LNO
terminal (8.5.3 Connection of the alarm
inputs, of the twilight switch and of the relays,
page 24).
• Internal: The reference probe for switching
between the two operative modes is the one
present within the LED illuminators.
• Camera: The switching between the two
operative modes takes place according to
the survey performed by the probe present
within the SONY module
IR Mode: If set to OFF it forces the day
2.
mode in a continuous manner (the switching on of
the illuminator, if present, is carried out by means of
the light sensitive switch or by means of the control
on the keyboard). If set to ON it forces the night mode
in a continuous manner. If set to Auto, it activates the
automatic switching of the camera.
Night Level: Sets the detection threshold of the
3.
light conditions for the night mode switching.
Lower values correspond to lower lighting
levels.
Night Delay: Sets the detection time of the
4.
darkness conditions, expressed in seconds,
before switching to night mode.
5. Day Level: Sets the detection threshold of the
light conditions for the day mode switching.
Lower values correspond to lower lighting
levels.
Day Delay: Sets the detection time of the
6.
light conditions, expressed in seconds, before
switching to night mode.
50
To avoid false switching, we recommend
choosing the higher day switching
threshold and delay values.
INFRARED
------------------------
1>IR PROBE
2 IR MODE
3 NIGHT LEVEL
4 NIGHT DELAY
5 DAY LEVEL
6 DAY DELAY
Fig. 102
This is a dynamic self-configuration menu based on
the choice made and shows the parameters on which
it is possible to operate.
The automatic Day/Night switching mode
of the module is strongly unadvisable
when swinging is subject to repeated
light variations during the night period,
for example during patrol, or due to the
switching on of auxiliary lighting devices.
Those situations can cause numerous
unwanted switching, compromising in this
way the functioning of the module.
: EXT.
: AUTO
: 5
: 5
: 20
: 30
MNVCUPTDMB_1511_EN