Troubleshooting; Warranty - Kärcher IV 60/30 Originalbetriebsanleitung

 Lift filter (C) and unscrew the two
screws (D). Remove the filter.
 Loosen the fastening clams and sepa-
rate the filter from its insert.
 Insert and secure the new filter in the re-
verse sequence of steps.

Troubleshooting

DANGER
Risk of injury by inadvertent startup of ap-
pliance and electrical shock.
First pull out the plug from the mains before
carrying out any tasks on the machine.
DANGER
Have all checks and works on electrical
parts performed by an expert.
Motor (suction turbine) does not
No electrical voltage.
 Check the receptacle and the fuse of
the power supply.
 Check the power cable and the power
plug of the device.
Protective motor switch was triggered.
 Reset switch.
Suction capacity decreases slowly
Filter, nozzle, suction hose or suction pipe
may be blocked.
 Check, clean the accessories, replace
the filter, if required.
16
start
Dust comes out during the
Filter has not been fastened correctly or is
defective.
 Check to see if filter is sitting properly;
replace if required.
Manometer indicates a negative
suction pressure below -0.16 bar
Filter is blocked.
 Switch off the appliance, clean the filter
or insert a new filter.
Customer Service
If malfunction can not be fixed, the de-
vice must be checked by customer ser-
vice.
The warranty terms published by our com-
petent sales company are applicable in
each country. We will repair potential fail-
ures of your accessory within the warranty
period free of charge, provided that such
failure is caused by faulty material or de-
fects in fabrication. In the event of a warran-
ty claim please contact your dealer or the
nearest authorized Customer Service cent-
er. Please submit the proof of purchase.
– 6
EN
vacuuming
(-16 kPa)

Warranty