Troubleshooting Guide; Technical Data - Kärcher SC 3 EasyFix Premium Plus Bedienungsanleitung

3. Press the RESET key and hold it while the device is
switched on.
Illustration G
After approximately 2 seconds, the indicator light
flashes and signals the current water hardness set-
ting with the number of pulses.
4. Press the RESET key repeatedly to change the wa-
ter hardness level.
Note
When the RESET key is pressed, the flash pulse for
the water hardness level is not indicated.
5. Release the RESET key.
The flash pulse for the set water hardness is indicat-
ed.
6. Repeat the process as necessary until the desired
water hardness level has been achieved.
7. Press and hold the RESET key for 3 seconds to
save the setting for the water hardness level.
The indicator light for the water hardness lights up.
Care of accessories
(Accessories - depending on scope of delivery)
Note
The floor cleaning cloth and the cover for the manual
nozzle have been washed beforehand and can be used
immediately for working with the appliance. The micro
fibre cloths are not suitable for dryer.
Note
When washing the cloths, observe the instructions on
the washing tag. Do not use any liquid softeners as this
will affect the ability of the cloths to pick up dirt.
1. Wash the floor cleaning cloths and covers at a max.
temperature of 60 °C in the washing machine.

Troubleshooting guide

Malfunctions often have simple causes that you can
remedy yourself using the following overview. When in
doubt, or in the case of malfunctions not mentioned
here, please contact your authorised Customer Service.
WARNING
Risk of electric shock and burns
Trying to eliminate faults while the appliance is connect-
ed to the mains or has not yet cooled down is always
dangerous.
Remove the mains plug.
Allow the appliance to cool down.
The water shortage indicator light flashes red
The dry-run protection for the pump is deactivated.
1. Switch the device off and back on again.
2. Make sure that the decalcification cartridge has
been inserted correctly and there is sufficient water
in the reservoir.
The water shortage indicator light lights up con-
stantly in red
No water in the water reservoir.
1. Top up the water reservoir, see chapter Topping up
the water.
The steam lever cannot be pressed
The steam lever is locked with the child lock.
 Set the child lock (selector switch for steam volume)
to the front.
The steam lever is released.
No / little steam although there is water in the reser-
voir
The decalcification cartridge has not been inserted or
has been inserted incorrectly.
16
Insert the decalcification cartridge or insert it cor-

rectly.
The decalcification cartridge has been removed while
topping up the water.
 Leave the decalcification cartridge in the device
when topping up.
New decalcification cartridge has been inserted.
 Press and hold the steam lever constantly.
The full steam output is reached after approximately
30 seconds.
Red indicator light "replace descaling cartridge"
lights up / flashes
Run time of the decalcification cartridge ends soon.
 Insert the new decalcification cartridge and reset the
maintenance indicator, see chapter Replacing the
decalcification cartridge.
The RESET key was not pressed after replacement of
the decalcification cartridge.
 Press and hold the RESET key for 4 seconds after
inserting the decalcification cartridge, see chapter
Replacing the decalcification cartridge.
Device switches off automatically
Run time for the decalcification cartridge has expired
 Insert the new decalcification cartridge and reset the
maintenance indicator, see chapter Replacing the
decalcification cartridge.
The RESET key was not pressed after replacement of
the decalcification cartridge.
 Press and hold the RESET key for 4 seconds after
inserting the decalcification cartridge, see chapter
Replacing the decalcification cartridge.

Technical data

Electrical connection
Voltage
Phase
Frequency
Protection class
Protection category
Performance data
Heating capacity
Maximum operating pressure
Heating-up time
Continuous steaming
Maximum steam blast
Filling quantity
Water reservoir
Dimensions and weights
Weight (without accessories)
Length
Width
Height
Subject to technical modifications.
English
V 220-240
~ 1
Hz 50-60
IPX4
I
W 1900
MPa 0.35
Seconds 30
g/min 40
g/min 100
l 1.0
kg 3.2
mm 360
mm 236
mm 252