Symbols On The Device; Initial Start-Up; Dry Vacuuming - Kärcher NT 30/1 Ap L Originalbetriebsanleitung

Symbols on the device

Dust class
WARNING: This device contains dusts that are harmful
to your health. Emptying and maintenance, including
removal of the dust bag, may only be performed by ap-
propriately trained personnel wearing suitable personal
protective equipment. Do not switch on until the entire
filter system is installed.
Main filter elements
Flat fold filter (cellulose)
Order number
Flat fold filter (PES)
Order number
Flat fold filter (PTFE)
Order number
Flat fold filter (PTFE H)
Order number
Candle filter
Order number
Preparation
1. Unpack the device and install the accessories.
Illustration B
Initial startup
WARNING
Danger from dust that is harmful to your health
Respiratory sicknesses through inhalation of dust.
Do not vacuum without correctly installed filter ele-
ments, otherwise a danger to health from increased fine
dust emission is present.
ATTENTION
Danger due to fine dust entering
Risk of damage to the suction motor.
Never remove the main filter element when vacuuming.
Anti-static system
Only for devices with a built-in socket:
Static charges are discharged through the earthed con-
nection nozzles. This prevents sparking and electric
shocks with electrically conducting accessories (option-
al).

Dry vacuuming

● NT 30/1: The device is fitted with a fleece filter bag
with cap, order no. 2.889-154.0 (5 pieces).
● NT 40/1, NT 50/1: The device is fitted with a fleece
filter bag with cap, order no. 2.889-155.0 (5 pieces).
14
Note
All types of dust up to dust class L can be vacuumed
with this device.
Note
The device is an industrial vacuum cleaner for vacuum-
ing dry, non-inflammable dusts with workplace limit val-
ues (AGW) greater than or equal to 1 mg/m
● When vacuuming fine dust, a fleece filter or dust bag
1. Unlock and remove the suction head.
2. Fit the fleece filter bag.
3. Fit and lock the suction head.
1. Unlock and remove the suction head.
2. Insert the dust bag (special accessories).
3. Pull the dust bag (special accessories) over the con-
6.904-367.0
4. Fit and lock the suction head.
6.907-662.0
Danger from dust that is harmful to your health
Respiratory sicknesses through inhalation of dust.
6.907-455.0
No dusts harmful to health may be vacuumed when per-
forming wet vacuum cleaning.
6.907-671.0
Note
The flat fold filter (cellulose) with the order number
6.904-367.0 available as an accessory is not recom-
2.414-000.0
mended for regular wet vacuum cleaning.
Note
The candle filter available as an accessory with the or-
der number 2.414-000.0 is not suitable for wet vacuum
cleaning.
1. Remove the brush strip.
2. Install the squeegees.
Note
The structured side of the squeegees must face out-
wards. Note the different lengths of the squeegees.
● The fleece filter bag must always be removed when
1. Unlock and remove the suction head.
2. Pull the fleece filter bag on the flange up and out.
3. Seal the fleece filter bag with cap.
4. Dispose of the used fleece filter bag in accordance
5. Fit and lock the suction head.
● The dust bag (special accessories) must always be
1. Unlock and remove the suction head.
2. Fold up the dust bag (special accessories).
3. Close the dust bag (special accessory) tightly with a
4. Take out the dust bag (special accessories).
5. Clean the container inside with a moist cloth.
English
(special accessory) can also be used.
Installing the fleece filter bag
Illustration C
Installing the dust bag
Illustration D
tainer. Ensure that the marking line is within the con-
tainer and both ventilation holes are positioned on
the back wall of the container.
Wet vacuum cleaning
DANGER
Installing the squeegees
Illustration E
Removing the fleece filter bag
vacuuming wet substances.
Illustration F
with statutory regulations.
Removing the dust bag
removed when vacuuming wet substances.
Illustration G
cable tie underneath the opening.
3
.