Cocraft TLG-150WG Original Bedienungsanleitung Seite 4

14. Look after your machine. Make sure that your machine is clean and that any
cutting edges are sharp for maximum effect and best results. Follow the instruction
manual's recommendations regarding lubrication and replacement of accessories.
Inspect the mains lead regularly. If it is damaged it should be replaced by
a qualified service technician. Inspect all leads and cables regularly to check for
any damage. Make sure that the handles and controls of the machine are clean,
dry and free from oil, grease etc.
15. Turn the power off. Pull out the plug and push in the emergency stop button
before servicing or changing any blades, drill bits, cutters or sanding discs.
16. Remove all spanners and repair tools. Make a habit of checking to make sure
that the machine is free of all spanners and tools before turning the power on.
17. Avoid unintentional starting. Do not walk around with your finger on the trigger
of a power tool if it is plugged in. Make sure that the on/off switch is set to OFF
before plugging in any power tool.
18. Use the correct extension leads. If you use extension leads outdoors, only
use those designed for outdoor use. Only use extension leads with thick enough
diameter core wires and roll out the whole lead.
19. Use common sense and be careful. Think before carrying out any task, so
that it is carried out safely. Never operate the machine when you are tired, under
the influence of medicine, etc.
20. Check the following before turning the machine on:
- That all guards and other parts are whole and in working order.
- That moving parts can rotate freely and are correctly aligned.
- That no moving parts can get caught.
- That there are no visible defects.
- That no other factors have occurred that could influence the execution of your work.
Any safety guard or other part that is damaged should be repaired by a tradesman
or replaced. Damaged power leads and switches must always be replaced by
a tradesman. Never operate a machine if you cannot stop or start the machine
comfortably.
21. Use only recommended accessories. The use of non-recommended accessories
can cause accidents and personal injury.
22. Should only be repaired by a qualified technician. This machine conforms to
current safety requirements. Repairs should only be carried out by a qualified repair
person using genuine identical replacement parts. Otherwise the machine could be
dangerous and cause an injury.
4