Sun Microsystems 220R Handbuch Zu Installation Und Rack-Montage Seite 28

4. Tie-wrap the power cord(s) to the strain relief(s) on the back panel.
The Sun Enterprise 220R server is shipped with two strain reliefs attached to the
back panel. A strain relief is a plastic tie-wrap on a base that is inserted into the back
panel of the system. Use these reliefs to manage the power cords when you slide the
system in and out of the rack enclosure.
To tie-wrap a power cord, wrap the loose end of the tie-wrap around the cord and
insert it into the opening on the base of the strain relief. Pull the end to tighten the
tie-wrap.
To release the tie-wrap from the cord, press down the tab on the strain relief base
and loosen the tie wrap.
Strain reliefs
Tab
en-24 Sun Enterprise 220R Server Setup and Rackmounting Guide • December 1999