Sun Microsystems 220R Handbuch Zu Installation Und Rack-Montage Seite 16

2. Attach a long mounting bracket to the rear end of each slide assembly.
a. Position the long bracket over the rear end of the slide assembly.
Align the elongated slots at the end of the long bracket over the holes on the slide
assembly, as shown.
b. Secure the long bracket loosely to the slide assembly. Use two 8-32 panhead
screws, flat washers, lock washers, and nuts for each long bracket.
Do not tighten the screws completely. You may need to adjust the mounting
bracket when you install the slide assembly into the rack enclosure.
Inner rail
3. Push in the inner rail and runner on each slide assembly.
a. Push the inner rail all the way into the slide assembly. If necessary, release the
coil spring catch.
b. Push in the runner until it stops.
en-12 Sun Enterprise 220R Server Setup and Rackmounting Guide • December 1999
Slide assembly
Front
Runner
Long bracket
Rear