Restore The Rack Enclosure; Power On The System - Sun Microsystems 220R Handbuch Zu Installation Und Rack-Montage

Restore the Rack Enclosure

See the instructions provided with the rack enclosure to complete these steps.
1. Route and manage the cables within the rack cabinet.
2. Retract the enclosure's anti-tip legs, if applicable.
3. Replace the side panels, if applicable.
4. Replace the front and back doors, if applicable.

Power On the System

Caution – Never move the system when the system power is on. Movement can
cause catastrophic disk drive failure. Always power off the system before moving it.
Caution – Before you power on the system, make sure that the cover is properly
installed.
1. Turn on power to any peripheral and external storage devices.
2. Turn on power to the monitor or terminal, if applicable.
Chapter 3 System Setup en-31