Note – You may need to slide the rear mounting bracket forward or backward on
the slide assembly to accommodate the depth of the rack.
3. Completely tighten all of the rackmounting screws.
a. Make sure that the slide assemblies are level front-to-back and left-to-right.
b. Tighten the eight 10-32 screws that secure the short and long mounting brackets
to the vertical rack rails.
c. Tighten the four 8-32 screws that secure the long mounting brackets to the slide
assemblies.
Tighten 10-32 screws
en-16
Sun Enterprise 220R Server Setup and Rackmounting Guide • December 1999
Tighten 8-32 screws