Checking The Chain Lubrication; Changing The Saw Bar; Sawing Techniques; General - FLORABEST FKS 2200 E3 Originalbetriebsanleitung

If the chain brake does not
function correctly, you must
not use the electric chainsaw.
A slack saw chain leads to
danger of injury.
Return the electric chainsaw
to our Service-Center for re-
pair.
Checking the chain
lubrication
Check the oil level and the chain lubrica-
tion system before commencement of work.
• Switch on the chainsaw and hold it
above a bright background. The saw
must not touch the ground.
If an oil trace can be seen, the chainsaw is
working trouble-free.
If no oil trace can be seen clean the
oil passages or turn the chainsaw
to our Service-Center for repair.
J 4. Clean the oil passages of the
chain bar (27), in order to guar-
antee a trouble-free, automatic
oiling of the saw chain during
operation.

Changing the saw bar

1. Switch the saw off and unplug it
F
from the mains.
2. Lay the saw on a flat surface.
3. Turn the fastening bolt (14) anti-
clockwise and loose the chain
adjustment ring (
the sprocket chain wheel cover-
ing (15).
IB-270730-FKS_2200_E3-RO-BG-GR-03112015-rev03-ts.indb 17

Sawing techniques

General

•
•
•
•
13) to remove
A
4. Remove the saw bar (4) and saw
chain ( 5). To remove the guide
A
bar (4), raise it to an angle of ap-
prox. 45 degrees. This will make
it easier to take the saw chain (5)
off the sprocket ( G
5. To fit the new bar, place the bar
(4) onto the bar bolt (22) with
the tensioning plate pointing out-
wards (24).
You have better control when you saw
with the bottom side of the chain bar
(with pulling saw chain) and not to with
the top side of the chain bar (with push-
ing saw chain).
The saw chain must not contact either
the ground or another object during
sawing through or after sawing comple-
tion.
Make sure that the saw chain does not
become jammed in the wood. Do not
let the tree trunk break or split off.
Consider also the precautions against
spring-back (see notes on safety).
If the saw chain jams, you
do not attempt to pull out the
electric chainsaw using pow-
er. There is a danger of injury
here. Switch off the motor
and use a lever or wedge to
free the electric chainsaw.
GB
25).
17
04.11.15 12:47