Maintaining The Chain Bar; Turn The Chain Bar; Waste Disposal And Environmental Protection - FLORABEST FKS 2200 E3 Originalbetriebsanleitung

Never attach a new chain
to a worn drive pinion or
place onto a damaged or
worn chain bar. The chain
could spring back or break,
potentially leading to serious
injury.

Maintaining the chain bar

Use cut-protection gloves
when handling the chain or
the chain bar.
1. Switch off the saw and pull out the
power plug (18).
2. Remove the sprocket chain wheel cov-
ering (15), the saw chain (5) and the
chain bar (4).
3. Check the chain bar (4) for wear. Re-
move burrs and straighten the guide
surfaces with a flat file.
4. Clean the oil passages (
the chain bar, in order to guarantee
a trouble-free, automatic oiling of the
saw chain during operation.
5. Mount chain bar (4), chainsaw (5) and
sprocket chain wheel covering (15)
and tighten the chainsaw.
With the oil nozzles in good condi-
tion and the oil regulator set cor-
rectly, the saw chain will spray a
little oil off after starting.

Turn the chain bar

Use cut-protection gloves
when handling the chain or
the chain bar.
The chain bar must be turned round every
10 working minutes, in order to guarantee
uniform wear.
IB-270730-FKS_2200_E3-RO-BG-GR-03112015-rev03-ts.indb 23
F
Waste disposal and
27) of
J
environmental protection
Do not dispose of used oil in the sewage
system or drains. Dispose of used oil in an
environmentally correct manner - bring it to
a waste disposal center.
Be environmentally friendly. Return the
tool, accessories and packaging to a recy-
cling centre when you have finished with
them.
Empty the oil tank carefully and hand in
your electric chainsaw at a disposal center.
The plastic and metal parts employed can
be separated out and thus recycled use
can be implemented. Ask our Service-
Center for details.
1. Switch off the saw and pull out
the power plug (18).
2. Remove the sprocket chain wheel
covering (15), the saw chain (5)
and the chain bar (4).
3. Put the sword (4) front and rotate
it on the back. Loosen the fixation
screw (28) and remove the tension-
ing plate (24).
4. Attach the tensioning plate (24)
with the fixing screw (28) from
the other side to the sword (4).
This, make sure that the clamping
screw bolt (29) is down. The
round nose (24a) the clamping
screw sprocket must point in the
direction.
5. Mount chain bar (4), chainsaw
(5) and sprocket chain wheel
covering (15) and tighten the
chainsaw.
Machines do not belong with do-
mestic waste.
GB
23
04.11.15 12:47