CO/Tech PN01-1200 Bedienungsanleitung Seite 9

5. Press [ PROG ] – the digits to the right of the colon
will flash.
- Press [ ] or [
15, that you wish the room to have outside of
the programmed time, or
- press [ ] (E) to select that the panel heater is
off outside the programmed time.
- The digits to the right of the colon will then be
replaced by "- -".
6. Repeat steps 1–5 if you wish to add more days to
the programme.
7. Press [ TIMER ] to activate the programme.
- A clock and a moon symbol will appear
on the display if you have selected that
the panel heater will also heat outside of
the programmed time.
- Only the clock symbol will appear on
the display if you have selected that the panel
heater will be off (in standby mode) outside of
the programmed time.
8. Pressing [ TIMER ] once again will deactivate
the programme. The clock and the moon symbol
will both disappear.
] to set the temperature, e.g.
9