CO/Tech PN01-1200 Bedienungsanleitung Seite 6

Activating the heating function
1. Set the main power switch (A) to [ I ] to switch the panel heater on.
2. Wait until the power cut alarm has emitted 10 signals or press [
Information
The number representing the day of the week must be visible in the upper left corner
of the display in order for settings to be made, otherwise the panel heater is in standby
mode. Press [ ] to deactivate standby mode.
3. The display now shows the current room
temperature (e.g. 16 °C).
4. Press [ ] or [ ] to set the preferred temperature
(5–35 °C).
- The heating symbol will appear when the selected
temperature is higher than the current room
temperature, as in the example shown, where
the ambient temperature is 16 °C and the set
temperature is 22 °C.
5. The current room temperature is shown on
the display again about 10 seconds after
the temperature setting has been made.
6. When the desired room temperature has been
reached, the heating symbol will disappear.
6
] (F) 2 times.