Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Open window alarm
If the temperature drops more than 5 °C in less than 10 minutes an alarm signal will
sound 3 times.
Power cut alarm
Important
•
The day of the week must always be reset after the panel heater has been
disconnected from the mains. This applies regardless of whether it was done
intentionally by switching it off using the main power switch on the back,
unplugging it or whether it was disconnected by a power cut.
•
Once the power has been restored to the panel heater following a power cut, the alarm
signal will sound 10 times every 30 minutes until the day of the week has been reset.
1. Press any button on the control panel to turn the alarm off.
2. Set the day of the week and the time (refer to the Setting the time and day section).
Information
The panel heater has a memory function for set programmes but the time setting
(time/day) must always be reset after a power cut.
Button lock
Important
Activation of the button lock is recommended to eliminate the risk of settings being
altered by accident.
1. Hold in [
] and [
2. Repeat the action to deactivate it.
Standby mode
Information
When in standby mode, no settings can be made and the panel heater does not emit any heat.
1. Press [
] to activate standby mode. The days of
the week will disappear from the display to indicate
that standby mode is activated.
] for 3 seconds to activate the button lock.
10
Werbung
Inhaltsverzeichnis
