Heyner MultiProtect ERGO SP Bedienungsanleitung Seite 11

English
2. GROUP II + III (about 15 to 36 kg)
HEYNER ® MultiProtect ERGO SP without harness belts
2.1. Using HEYNER
Fig.18 - 20
Release the harness central belt (D3) from the belt end element (I), press the adjuster (H) and pull
the harness central belt from the belt adjuster (H) (fig.18). Release the belt loops from the metal belt
anchorage (K) on the back of the seat, release the shoulder pad connector (W). (fig.20)
Fig.21
Turn the seat upside down. Pull the waist belts (D2) down a little bit and peel off the belt anchorage
of waist belts (X). Pull the buckle belt (D4) down a little bit and peel off the belt anchorage of buckle
belt (Y).
Fig. 22
Turn the seat into sitting position, finally pull the harness belts firmly up and remove it from the seat
including the belt buckle.
Fig. 23
HEYNER ® MultiProtect ERGO SP onto any passenger car seat equipped with a
Now place HEYNER
three-point-vehicle-belt and set your child into it.
Fig.24
Secure your child in it by fastening the lap and diagonal belts of the three-point-vehicle-belts and
locking it with an audible »click« sound. The lap belt (O) needs to lead under the fixation lugs (L) on
both sides. The diagonal belt (N) needs to lead under the fixation lugs (L) only on the belt buckle (Q)
side.
www.heyner-germany.de
17
Fig.25
Thread the diagonal belt through the belt guide (1 or 10) at the headrest and tighten it in the
direction of the retracting mechanism. Make sure that the diagonal belt lies firmly against the
child's body and is not twisted.
2.2. Adjusting the headrest to your child's size (fig. 2d)
In order to adjust the height of the head rest to your child's size push the seat down on the
vehicles seat to keep it there. With the other hand de-block the head rest de-block lever (Z) on
the back of the head rest by pulling it backwards at the same time. Keep the lever de-blocked
and pull the head rest simultaneously up or down, according to the child's size. Relase the
lever. The head rest needs to be fixed in one of the guide wholes with an audible sound. Please
check by pulling on the head rest, if it does not move anymore without pulling the lever. The
middle of the head rest needs to be exactly at the height of the middle of the child's head to
have the highest side protection effect. The distance between head rest and shoulder of the
child should be 2 fingers. The headrest is adjustable in 7 different positions.
Warning:
HEYNER ® MultiProtect ERGO SP without backrest (B). In that case, the child
Do not use HHEYNER
can not get enough side protection in an accident.
Do not fasten the belts in any other way than described here, otherwise the child will not be
held or secured properly. Make sure that the diagonal belt is carefully positioned and does not
run too close to the child's neck. All belts must lie firmly against the child's body without
twisting. If necessary, install a height adjuster mechanism into the car to correspond to your
child's size.
www.heyner-germany.de
English
GB
HEYNER
HEYNER
HEYNER
18