Handling - Conrad Electronic RGP600 Bedienungsanleitung

12. Handling

Take note of all safety instructions contained in this operating manual as well as all other
instructions in the corresponding chapters.
• Never touch the mains plug when your hands are wet or damp. There is a risk of a fatal electric shock.
• Avoid the following unfavourable environmental conditions at the installation location and during
transportation:
- extreme cold or heat
- direct sunlight
- Dust or combustible gases, vapours or solvents
- Strong vibrations
• Make sure that the garden pump is also sufficiently ventilated. The garden pump heats during
operation. Never cover the garden pump in a way that hinders air circulation!
• Do not touch the openings of the product; do not put objects in the openings.
• When the product is brought from a cold into a warm room condensation may form.
Leave the product until it reaches room temperature before using it. This may take several hours.
There is the risk of a lethal electric shock (e.g. if the mains plug is damp with condensation water).
• Ensure during installation and operation not to bend, jam or damage neither the mains cord nor the
hoses.
• Check the product regularly for damage or leakage.
If you notice damages, the product must NOT be used; disconnect it immediately from the mains
voltage and take it to a specialized workshop.
• It can be assumed that safe operation is no longer possible if:
- the device is visibly damaged,
- the device is no longer functional and
- the unit was stored under unfavourable conditions for a long period of time or
- if it has been subjected to considerable stress in transit.
• Do not pull the mains plug from the mains socket by pulling the cable Always pull the plug from the
mains socket by the gripping area provided on the side. Otherwise the power cord may get damaged,
risk of an electric shock!
• Never dismantle the garden pump. There are no serviceable parts inside the water pump. The mains
cable can only be exchanged by an expert. Repair or maintenance work must be carried out by a
specialist!
27