Setting Data Function; Audio; Setting Audio Profiles - Motorola MTP3250 Funktionsbenutzerhandbuch

68015000899–FC (en-US)
Chapter 4: Main Menu
To connect your radio accessory connector to the external device, use the PMKN4127 or PMKN4129
cable. The external device must run an application complying with the TETRA standards.
NOTICE:
• Data services are available only in TMO Mode.
• Data services are blocked in TXI Mode.
• When set to Voice Only, the built-in data modem is disabled to conserve battery power.
4.8.4.1

Setting Data Function

Procedure:
1 From the home screen, press the Menu key.
2 Select Setup → Data Setup.
3 Select one of the following:
• Voice Only – Your radio receives and transmits voice calls only.
• Data Only – Your radio acts as a modem. It rejects incoming and outgoing voice calls
(except for Emergency Calls), status and text messages.
• Voice & Data – Your radio acts as a modem but voice calls have priority over data calls and
can interrupt them.
4.8.5

Audio

This menu item allows you to adjust your radio audio settings.
4.8.5.1
Audio Profiles
An audio profile is a set of audio parameters, such as the volume of alert tones, that are configured by
your service provider to fit a particular operating environment. For example, the audio parameters can
be adjusted to situations when the radio operates inside a building or on a noisy street.
Your service provider can configure a maximum of five audio profiles.
For a detailed description of a specific audio profile, contact your service provider.
4.8.5.1.1

Setting Audio Profiles

When and where to use: To adjust the audio parameters of the radio in its current operating
environment.
Procedure:
1 From the home screen, press the Menu key.
2 Select Setup → Audio → Audio Profile.
3 Select a required profile.
90 Send Feedback