Changing Gnss Accuracy; Backlog; Enabling Or Disabling Backlog; Viewing Backlog Reports - Motorola MTP3250 Funktionsbenutzerhandbuch

68015000899–FC (en-US)
Chapter 4: Main Menu
• Version – displays detailed information on software version: SW (software version), HW
(hardware version), ASIC (application-specific integrated circuit), RC (release code).
4.16.4

Changing GNSS Accuracy

Procedure:
1 From the home screen, press the Menu key.
2 Select Location → Accuracy.
3 Select one of the following:
• Medium (default) – Power consumption optimization is combined with less position accuracy.
• High – Better position accuracy is combined with less power consumption optimization.
NOTICE: If connected to an external charging device, the radio automatically enters the
High mode.
4.16.5

Backlog

This sub-menu allows you to enable/disable, view, and delete backlog reports.
NOTICE: The location report backlog is only available when Local Information Protocol (LIP) is
enabled.
4.16.5.1

Enabling or Disabling Backlog

Procedure:
1 From the home screen, press the Menu key.
2 Select Location → Backlog → Enablement.
3 Select one of the following:
• On – Activates location report backlog recording.
• Off – Deactivates location report backlog recording.
4.16.5.2

Viewing Backlog Reports

Procedure:
1 From the home screen, press the Menu key.
2 Select Location → Backlog → Reports.
The radio displays the number of backlog reports stored.
4.16.5.3

Deleting All Backlog Reports

Procedure:
1 From the home screen, press the Menu key.
116 Send Feedback