Signal Button; "R" Button On Private Exchanges - AUDIOLINE BigTel 48 Bedienungsanleitung

R−Signal Button
5 R−Signal Button
5. The "R" signal button
You can use the "R" signal button on your telephone on private exchanges
and when using DEUTSCHE TELEKOM's T−Net functions.
5.1

"R" button on private exchanges

If you have connected your telephone to a private exchange, you can use
all the facilities such as call transfer, automatic recall, etc. The "R" signal
button gives you access to these facilities. The FLASH time "100ms" will
be required on a private exchange.
For this purpose, set the "FLASH" switch to the "100ms" setting.
You can find out from the dealer from whom the equipment was purchased
whether your telephone will work on your private exchange without any
problems and what further facilities you will receive from this.
5.2 "R" button and the Deutsche Telekom T−NET functions
Your AUDIOLINE Telephone BIGTEL 48 supports the most important
DEUTSCHE TELEKOM added value functions (e.g. brokering, call wai-
ting, three−way conference, etc.). The T−NET works using the "FLASH
300ms" setting.
For this purpose, set the "FLASH" switch to the "300ms" setting.
Please contact DEUTSCHE TELEKOM to gain access to the T−NET func-
tions (some of which are subject to charge).
5.3 Dialling and storing telephone numbers when using on private
exchanges
Note!
The pause function after an outside line code (usually 0 or 9) described in
this chapter is only required on older private exchanges.
With some private exchanges, there is a short pause between the code for
the outside line (usually 0 or 9) and the dialling tone. When dialling ma-
nually and when dialling using the direct dial and speed dial buttons, this
pause can be entered along with the number so that the following digits
are not dialled too quickly.
20
Service−Hotline Germany: Tel. 0180 5 001388, cost via German landline at time of going to print: 14 ct/min., different costs possible via mobile telephone systems
5.3.1 Entering the pause when dialling manually
d
Press the button once between the number for the outside line and
the actual telephone number. The pause will be shown by a "P" in the dis-
play. After connecting to an outside line your telephone will wait for three
seconds before dialling the actual telephone number.
5.3.2 Storing the pause
When storing a number, simply press the
the outside line and before the actual telephone number. The pause will
be shown by a "P" in the display. When dialling using the direct dial or
speed dial buttons a pause of three seconds will automatically be inserted
after the number for the outside line.
d
button after the number for