Operation - AUDIOLINE BigTel 48 Bedienungsanleitung

Operation

4 Operation
4.1 Using the telephone
The AUDIOLINE Telephone BIGTEL 48 can be used like any conventional
telephone.
PLEASE FOLLOW THE INSTRUCTIONS:
1. Lift the receiver and wait until you hear the dialling tone.
2. Now dial the required telephone number. The number dialled will be
shown in the display. The display shows a telephone number with a
maximum of 16 digits. If the number dialled is longer, only the last 16
digits will be displayed.
3. To end the call simply replace the receiver.
4.2 Receiving calls
As soon as you receive a call you will hear the ringing tone and the visual
call indicator will come on at each ring.
The call can now be accepted by lifting the receiver.
4.3 Increasing the volume of the receiver
If the caller's voice should ever be too quiet, you can increase the volume
of the receiver.
ab
Simply press the
Note: The changed volume setting is not saved and must be increased
again for the next call if required.
4.4 Redial
If a connection that you have dialled is engaged or you were unable to get
through to anybody, simply replace the receiver. The last number dialled
remains stored in the telephone automatically.
To use the redial facility, proceed as follows:
1. Lift the receiver and press the redial button
number will now be dialled.
18
Service−Hotline Germany: Tel. 0180 5 001388, cost via German landline at time of going to print: 14 ct/min., different costs possible via mobile telephone systems
button during the call.
d
. The stored redial
4.5 Call duration display
After dialling the telephone number, the current call duration in minutes
and seconds will be shown in the display after a few seconds.
You can also use the internal clock as a stopwatch. To do this, press the
f
button with the receiver on the hook or even during a call. The time
measurement can be stopped using the same button
time will still be shown in the display for a few seconds and the display
then jumps back to showing the present time.
4.6 Adjustable ringing tone
By means of the "Ringer" slide switch on the right−hand side of your tele-
phone you can choose the settings "SOFT" (
volume of the ringing tone to your requirements. If at any time you do not
want to be disturbed, use the "OFF" setting.
4.7 Storing direct and speed dial numbers
You can store a telephone number for direct dialling on each of the buttons
M1, M2 and M3 with your AUDIOLINE Telephone BIGTEL 48. The direct
dial button M1, M2 and M3 are coloured red and suitable for use as emer-
gency call buttons. An additional ten important numbers can be stored as
speed dial numbers.
PLEASE FOLLOW THE INSTRUCTIONS:
1. Lift the receiver.
2. Press the store button
3. Now enter the required telephone number using the number pad. The
maximum length is 16 digits.
4. Press the store button
5. Now press the required direct dial button M1, M2 or M3 or a button on
the number pad between 1 to 9 or 0 to save the telephone number as
a speed dial number.
6. Replace the receiver.
f
. The measured
i
), or "LOUD" to match the
c
.
c
again.