The "R" Signal Button - T-Net Set-Up; R" Button On Private Exchanges; R" Button And The Deutsche Telekom T-Net Functions; Important Information - AUDIOLINE TEL4clip Bedienungsanleitung

5.

THE "R" SIGNAL BUTTON - T-NET SET-UP

You can use the "R" signal button on your telephone on
private exchanges
TELEKOM's T-Net functions.
5.1

"R" BUTTON ON PRIVATE EXCHANGES

If you have connected your telephone to a private
exchange, you can use all the facilities such as call transfer,
automatic recall, etc. The "R" signal button gives you
access to these facilities. The FLASH time "100ms" will be
required on a private exchange. For this purpose, set the
"R" slide switch to the "100ms" setting. You can find out
from the dealer from whom the equipment was purchased
whether your telephone will work on your private exchange
without any problems and what further facilities you will
receive from this.
5.2 "R" BUTTON AND THE DEUTSCHE TELEKOM
T-NET FUNCTIONS
Your AUDIOLINE TELEPHONE 4clip supports the most
important DEUTSCHE TELEKOM added value functions
(e.g. brokering, call waiting, three-way conference, etc.).
The T-NET works using the "FLASH 300ms" setting. For
this purpose, set the "R" slide switch to the "300ms" setting
Please contact DEUTSCHE TELEKOM to gain access to
the T-NET functions (some of which are subject to charge).
6.

IMPORTANT INFORMATION

6.1

FAULT FINDING

Remove all extra telephone equipment and connect only
the telephone directly to the telephone socket. If the fault is
still there, connect a different telephone (if available) to the
telephone socket. The results will show you whether the
fault lies with the unit or with the telephone line. Of course,
you can always ring your telephone network provider's
service department, which will give you more advice on
checking your installation.
6.2

REPLACING THE TELEPHONE CABLE

If you have to replace your telephone cable, you can locate
the appropriate cable at your dealer's with the help of the
diagram below.
and when
Modular Plug
Type RJ 11 6/4
a
b
a => TAE Plug Pin 1
b => TAE Plug Pin 2
21
using
TAE Plug
Coding "F"
4 3
5 2
6 1
DEUTSCHE