Installation; Connecting The Receiver; Insert Battery; Connecting The Telephone - AUDIOLINE BigTel 48 Bedienungsanleitung

Installation

3 Installation
3.1

Connecting the receiver

After unpacking your telephone, you must first connect the telephone re-
ceiver to the base unit. The spiral cable needed for this has two identical
connections so that there can be no confusion. First take one end of the
spiral cable and plug it into the socket at the bottom of the receiver. Now
plug the other end into the socket on the left−hand side of the base unit.
3.2

Insert battery

Before connecting your new telephone to the telephone network, the sup-
plied battery should be installed. Please always use type AAA 1.5V alka-
line batteries. The batteries are required for the display and other features
of the telephone. Before installing or changing the batteries make sure that
the telephone is not connected to the telephone network. The battery com-
partment is to be found on the underside of your telephone.
1. Open the battery compartment with a small screwdriver or a pointed
object.
2. Insert the battery. Ensure that the polarity is correct. Push the "−" pole
onto the small spring and then press the "+" pole downwards.
3. Close the battery compartment.
The battery must be changed when the display is no longer visible.
3.3

Connecting the telephone

Connect the telephone cable provided to the telephone jack and the tele-
phone socket on the rear of the telephone. The AUDIOLINE Telephone
BIGTEL 48 works using the TTD system (Touch−Tone Dialling).
16
Service−Hotline Germany: Tel. 0180 5 001388, cost via German landline at time of going to print: 14 ct/min., different costs possible via mobile telephone systems
3.4

Wall mounting

Your AUDIOLINE Telephone BIGTEL 48 is also suitable for wall mounting.
Use the two screws for fixing it to the wall. Drill two holes 83 mm apart and
leave the screws protruding 5 mm from the wall. Now place the telephone
over the screws and push down slightly.
Abb. A
When the telephone is used on a table, the receiver hanging hook must be
in the flush position as shown in diagram A (factory setting). When moun-
ting on the wall, the telephone receiver hanging hook is pulled out and ro-
tated. See diagram B.
3.5

Hearing aid compatible

The telephone has a special circuit working on the basis of induction for
transmitting speech to hearing aids. Please set your hearing aid to "T".
Abb. B