Herunterladen Diese Seite drucken

Troubleshooting; Fault Indication; Warranty - Kärcher IV 100/55 H B1 Bedienungsanleitung

Vorschau ausblenden Andere Handbücher für IV 100/55 H B1:

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
 Remove the H filter cartridge upward.
 Immediately place the H filter cartridge
into the included bag and close it after
you remove it.
 Dispose of the used H filter cartridge in
a dust-tight bag according to the statu-
tory provisions.
 Open the knot of the tapes on the filter
and remove the frame.
 Remove the M filter.
 Immediately place the M filter into the
included bag and close it after you re-
move it.
 Dispose off the used M filter in a dust-
tight bag according to the statutory pro-
visions.
 Insert and secure the new filter in the re-
verse sequence of steps.

Troubleshooting

Note
In case of a failure (e.g. filter breakage) the
appliance must be turned off immediately.
The failure must be remedied before the
appliance is put into operation again.
Motor (suction turbine) does not start
No electrical voltage.
 Check the receptacle and the fuse of
the power supply.
 Check the power cable and the power
plug of the device.
Protective motor switch was triggered.
 Reset switch.
Suction capacity decreases slowly
Filter, nozzle, suction hose or suction pipe
may be blocked.
 Check, clean accessories. Clean filter.
Dust comes out during the vacuuming
Filter has not been fastened correctly or is
defective.
 Check to see if filter is sitting properly;
replace if required.
Manometer shows a pressure level that
is not correct
Filter is blocked.
 Switch off the appliance, clean the filter.
20
Warning
All checking and work on electrical parts
must be performed by an authorized elec-
trician. In the event of continuing faults,
contact Kärcher customer service.

Fault indication

1 Indicator lamp "Mains voltage present"
Glows when the mains plug is inserted
and mains voltage is present.
2 Indicator lamp "Wrong rotation direction"
Glows when the rotation field at the
main connection is wrong.
 Exchange the poles at the device plug if
the rotation direction is wrong .
The warranty terms published by the rele-
vant sales company are applicable in each
country. We will repair potential failures of
your appliance within the warranty period
free of charge, provided that such failure is
caused by faulty material or defects in man-
ufacturing. In the event of a warranty claim
please contact your dealer or the nearest
authorized Customer Service centre.
Please submit the proof of purchase.
– 8
EN

Warranty

Werbung

loading