Setting The Clock; Proceed As Follows; Using Immediate-Start Function - Silvercrest SDG 800 A1 Bedienungsanleitung

points to the front towards the keypad and is
level. Thus, the turbo ring
position.
j 
P lace the food in the steam trays
j 
E nsure that all parts are positioned correctly
before switching on the appliance.
AttEntIOn! Never use bowls or other parts,
not especially produced for this appliance.
Otherwise, there may be the risk of injuries
and / or damage of the appliance.
j 
N ow place the steam trays
1 - 2 - 3 succession (please see the markings on
the handles) on top of the condensate collection
basin .
7
j 
P lace the cover
1
steam tray is completely closed and no
3
steam can exhaust.
j 
C onnect the mains plug
j 
T he LC display shows "45" (see Fig. B).
13
Now your steamer is ready for use.

Setting the clock

Q 

Proceed as follows:

j 
S imultaneously press the PROG
OFF buttons for 2 - 3 seconds. A signal tone
14
will be heard on releasing the buttons.
j 
P ress the PLUS button
indicator by 10 minutes each time. Press the
20
MINUS button
16
by 1 minute each time.
20
j 
P ress the PROG button
j 
T he LCD-display
13
clock time (clock time mode).
Using Immediate­Start Function
Q 
note: Consider that the base of the appliance /
water tank has to be filled with water at least
10
up to the MIN mark . Ensure that the turbo ring
9
in addition to the condensate collection basin
has been correctly positioned.
will be kept in
8
, ,
3 4
, , in
3 4 6
centrically so that the upper
to a suitable socket.
18
and ON /
17
to increase the time
16
to reduce the time indicator
to confirm your setting.
17
will now show the current
j 
P ress the ON / OFF button
play will show the factory-set steaming time
13
of 45 minutes (see fig. B).
j 
. P ress the PLUS / MINUS button
6
the steaming time in 5-minute steps or decrease
it in 1-minute steps.
note: The maximum steaming time is 90 minutes.
note: Be aware that you might have to replen-
ish water when the steaming time is longer.
Use the openings on the sides of the conden-
sate collection basin
of the appliance / water tank
the MAX mark
1 hour of steaming.
AttEntIOn! HAzArD OF BUrnS!
Make sure that the water does not exceed the
MAX mark
out of the steamer during operation.
j 
P ress the ON / OFF button
a beep. The red indicator light
and the device starts the steaming process.
j 
T he LCD-display
steaming time.
AttEntIOn! HAzArD OF BUrnS! The
appliance will become hot during use. Beware
of getting in contact with the ascending steam
or any components.
j 
I f the set steaming time is elapsed, the appli-
ance will automatically switch back to the
keep-warm mode (see "keep-warm mode").
note: You can increase the steaming time at
any time in 5-minute steps or decrease it in
1-minute steps by pressing the PLUS / MINUS
button
. As soon as the steaming time is set
16
manually to "0", the device switches automati-
cally into the warm mode (see "Warm mode").
AttEntIOn! HAzArD OF BUrnS!
Always lift the cover
from you and let the steam exhaust backwards.
Do not bend over the appliance during steam
generation. Use oven cloths when touching the
cover and the steam trays
1
a long fork or tongs when checking if the food
8
is done.
7
j 
P ress the ON / OFF button
steaming process prematurely or to switch off
Initial Operation
. The LCD dis-
14
16
for refilling. If the base
7
is filled up to
10
, it will be sufficient for approx.
19
. Otherwise, hot water may spurt
19
. The device sounds
14
comes on
15
will indicate the remaining
13
slowly, turning away
1
,
3
to terminate the
14
to increase
, . Use
4 6
GB/MT 53