Taking Care Of The Guide Bar; Storing The Machine - Stihl HTE 60 Gebrauchsanleitung

English
Taking Care of the Guide
Bar
2
1
Turn the bar over – every time you
N
sharpen the chain and every time
you replace the chain – this helps
avoid one-sided wear, especially at
the nose and underside of the bar.
Regularly clean the oil inlet hole (1),
N
the oilway (2) and the bar
groove (3).
Measure the groove depth – with
N
the scale on the filing gauge (special
accessory) – in the area used most
for cutting.
Chain type Chain pitch Minimum
groove depth
Picco 3/8" P 5.0 mm
Rapid 1/4" 4.0 mm
If groove depth is less than specified:
Replace the guide bar.
N
48
The drive link tangs will otherwise
scrape along the bottom of the groove –
the cutters and tie straps will not ride on
the bar rails.
3

Storing the Machine

For periods of 3 months or longer
Disconnect the plug from the wall
N
outlet.
Remove the saw chain and guide
N
bar, clean them and spray with
corrosion inhibiting oil.
If you use a biological chain and bar
N
lubricant, e.g. STIHL BioPlus,
completely fill the chain oil tank.
Store the machine in a dry, high or
N
locked location – out of the reach of
children and other unauthorized
persons.
HTE 60