Bertos ELT 4 B Bedienungsanleitung Seite 30

CARE OF THE APPLIANCE
ATTENTION!
- Before cleaning, switch off the unit and let it cool
down.
- In the event of electrically supplied units, use the
isolator switch to disconnect the mains.
Carefully clean daily the appliance to guarantee its proper
operation and long life.
Steel surfaces must be cleaned with a dish washer detergent
diluted in very hot water by using a soft cloth; for the toughest
dirt, use ethylic alcohol, acetone or another non-halogenated
solvent; do not use abrasive powder detergents or
corrosive substances such as hydrochloric acid, muriatic
or sulphuric acid. The use of acids can affect the unit's
operation and safety.
Do not use brushes, steel cottons or abrasive disks made
with other metals or alloys that might cause rust stains due
to contamination. For the same reason, avoid contact with
iron objects.
Do not use steel cottons or stainless steel brushes because
whilst they will not contaminate surfaces, they can cause
damaging scratches.
Metal powder, metal shavings from working and iron material
in general, when in contact with stainless steel surfaces, can
cause rust stains.
Superficial rust stain might be present on new appliances
and they can be removed with a detergent diluted in water
and a Scotch Brite sponge.
If dirt is tough, do not use sandpaper or rough paper, but use
synthetic sponges (for example Scotchbrite sponges).
Do not use substances for cleaning silver and be careful with
hydrochloric or sulphuric vapours coming from floor washing
products, for example. Do not aim water jets directly on
the appliance, it might be damaged. After cleaning, rinse
properly with clean water and dry carefully with a cloth.
CLEANING THE TANK
The following operations must be carried out when the unit
is off, cooled and electrically disconnected from the main
power supply.
ELT series models
Loosen the "V" screw (see fig. 2) to extract the head group
holding the heating elements and drain the tank by means of
33851000_Man_Friggitrici_Elettriche.indd 30
ENGLISH
the "L" level and later filter the oil with the proper filter.
A few fryer models are equipped with an extractable tank;
to remove the oil, extract the tank when the unit is cool and
then clean the tank, filtering the oil or replacing it.
After cleaning, refer to CARE OF THE APPLIANCE , position the
head group back into its seat and set it properly.
Other models
The heating element group can be lifted up to be cleaned
better and more easily.
Empty the tank by using the "L" lever and filter the oil with
the proper filter.
Manually activate the heating element group until locked in
the lifted position.
Perform all cleaning operations as described within the
paragraph CARE OF THE APPLIANCE , position the heating
element group back.
In the 600 and 700 series models, the heating element group
can be unlocked by pressing the button positioned on the
left of the heating element group (see fig. 3).
PRESERVATION AND STORAGE
If the appliance is not used for long periods of time, please
observe the following:
1) Switch off the disconnecting switch to disconnect the
mains
2) Clean the equipment and the surrounding areas properly
3) Pour a small quantity of cooking oil on the stainless steel
surfaces
4) Carry out all maintenance operations
5) Cover all appliances with a suitable material and leave a
few openings to allow air to circulate
6) Use in dry places with temperatures between –5 e +40°C.
HOW TO ACT IN THE EVENT OF A FAILURE
In the event of a failure, immediately disconnect the unit from
the main power supply and contact the Assistance Service.
WARNING!
In the event that the fryer has to be transported, empty
the tank before moving the transportation means.
The tank might be damaged from movements and oil
might be spilled over.
30 30
07/01/2010 14.35.45