Before Start Of Operation; Insert / Replace Battery; Preparing The Caliper; Starting Up The Device - Powerfix Z22855 Bedienungsanleitung

J
Wear protective gloves! If they come into contact
with skin, leaked or damaged batteries could cause chemi-
cal burns; you should therefore wear suitable protective
gloves at all times if such an event occurs.
J
Avoid contact with skin, eyes, and mucous membranes. If
you come into contact with battery acid, rinse the affected
spot with plenty of water and / or consult a doctor immedi-
ately!
J
WARNING!
the battery (LCD display
J
Remove the battery from the device if it is not in use for a
long period of time.
J
Do not, on any account, short-circuit the terminals.

Before start of operation

Q

Insert / replace battery

Q
Tip: Flashing numbers indicate a discharged / flat battery.
Tip: When changing the battery, the LCD display
experience faults. Remove the battery and insert it again after
waiting more then 30 seconds.
j
Push open the lid to the battery compartment
j
Remove the old battery.
j
Insert the new battery into the battery compartment and
ensure correct polarity (+ and -). Make sure that the plus
terminal points outwards.
j
Push the lid to the battery compartment
(see Fig. B).

Preparing the caliper

Q
j
Loosen the locking screw
caliper.
j
Clean all measuring surfaces and the caliper rod. Otherwise,
faulty measuring results may occur due to, for example,
humidity.
j
Check that all keys, switches and the LCD display
correctly.

Starting up the device

Q

Using the caliper

Q
j
Loosen the locking screw
j
Push the external measuring jaws
uring jaws
2
j
Switch the LCD display
8 GB/IE
Switch the product OFF before inserting
is off.)
5
so that you can move the
4
by turning it anti-clockwise.
4
together.
on by pressing the ON / OFF key
5
may
5
(see Fig. B).
8
shut again
8
5
and the internal meas-
11
work
.
10