Introduction; Intended Use; Product Description - Reely SKY Extra 300 Bedienungsanleitung



1. Introduction

Dear Customer,
Thank you for purchasing this product.
This product meets the requirements of current statutory, European and national guidelines.
These operating instructions are part of this product. They contain important information on how to put the product into operation and
how to handle it. Please take this into consideration when you pass the product on to third parties.
Please keep these instructions for further reference!
All company names and product designations contained herein are trademarks of the respective owners. All rights reserved.
In case of any technical inquiries, contact or consult:

Tel. no.: +49 9604 / 40 88 80
Fax. no.: +49 9604 / 40 88 48
E-mail: tkb@conrad.de
Mon. to Thur. 8.00am to 4.30pm
Fri. 8.00am to 2.00pm


2. Intended use

This product is an electrically driven model plane. It is controlled wirelessly using a remote control which has to be purchased separately. The model is designed
for outdoor use and should only be operated in soft wind conditions or windless conditions. The plane is preassembled and can be completed to be ready to fly
in a short period of time.
The product must not get damp or wet.
The product is not a toy. It is not suitable for children under 14 years of age.
Observe all the safety instructions in these operating instructions. They contain important information regarding the handling of the product.
You are solely responsible for the safe operation of the model!


3. Product description

The "Extra 300" model plane is a pre-fabricated ARF model (ARF = "Almost Ready to Fly") suitable for model plane novices as well as experienced model plane
pilots due to its design as a mid-wing plane and due to the choice of the wing profile.
The fuselage, the wings and the stabilisers are pre-fabricated and decorated. The plane is equipped with a zipper in the fuselage which provides an installation
opening that allows you to clearly view and complete the model and to easily access the RC components.
To enable easy ground take-offs, the rear landing gear of the two-leg landing gear is controlled as well.
The model can be controlled over three axes. It can be easily equipped with the required remote control components and finished within a short period of time.
The controllable features are: aileron (longitudinal axis), elevator (lateral axis) and rudder (vertical axis) as well as the speed of the electric motor.
18