Reely REX-X Pro Wichtige Informationen Seite 42

Then determine the exact position of the joint socket on
the servo lever (7).
The distance of the joint socket from the pivot point of the
servo lever should then be 7 to 8 mm. Contrary to the
swash plate control, you now attach the joint ball on the
opposite side of the servo lever.
Then suspend the front joint socket of the tail rotor control
in the ball on the servo lever and attach the lever to the
servo.
The servo lever and the control wire must be aligned at
an exact 90° angle towards each other and the control
wire (2) for the tail rotor control must run absolutely straight.
Now shift the tail rotor servo incl. support so far that the
tail rotor control lever (6) on the bottom of the tail rotor
mechanics is also at a 90° angle to the control wire (2).
Then screw the servo support tight on the tail pipe in this
position.
Figure 8
40