High-Pressure Hose And Spray Gun; Connection To The Mains; Cleaning Preserving Agent When Starting-Up Of Operation Initially; Ventilate Unit (Hydraulic System) If The Sound Of The Inlet Valve Is Not Audible - WAGNER Super Finish 31 Betriebsanleitung

5
6
7
1

4.3 High-pressure hose and spray gun

1. Screw the high-pressure hose (fig. 8, item 1) onto
the hose connection (2).
2. Screw the spray gun (3) with selected tip onto the
high-pressure hose.
3. Tighten the union nut on high-pressure hose so
that no coating material escapes.
3
1
2
Super Finish 27 • 31
g

4.4 Connection to the mains

The connection must take place through
a correctly earthed two-pole and-earth
socket outlet.
Attention
3
Before connection to the mains, pay attention to the fact
that the mains voltage agrees with the information on the
2 makers' name plate on the rear of the unit.
The green control lamp will light up as soon as the mains
4
plug has been connected.
4.5 Cleaning preserving agent when
starting-up of operation initially
1. Unit with suction system
Submerge suction pipe into a vessel filled with a
suitable cleaning agent
2. Unit with upper hopper
Fill suitable cleaning agent into the upper hopper.
Set multifunction switch (fig. 9, item 1) to E (ON
3.
– circulation); the unit commences to run. Turn
pressure regulation knob (2) to the right until stop.
4. Wait until the cleaning agent flows out at the re-
turn pipe.
Set multifunction switch (1) to S (spray). Pull trig-
5.
ger guard of spray gun.
6. Spray cleaning agent from the unit into an open
collection container.
1
4.6 Ventilate unit (hydraulic system) if
the sound of the inlet valve is not
audible
1. Turn pressure regulating knob (fig. 10, item 1)
three revolutions to the left.
Set multifunction switch (2) to E (ON – circula-
2.
tion). The hydraulic system is ventilated. Leave
the unit on for two to three minutes.
3. Then turn the pressure regulating knob (1) to the
right until stop.
Sound of the inlet valve is audible.
4. If not, repeat points 1 and 3.
Starting operation
2
31