Ups Installation - Eaton 9910-P33 Installationsanleitung

UPS Installation

NOTE Do not make unauthorized changes to the UPS; otherwise, damage may occur to
your equipment and void your warranty.
To install the UPS:
1.
2.
X-Slot Communication
Ground Bonding Screw
3.
4.
®
EATON Powerware
If you are installing power management software, connect your
computer to the UPS communication port or optional X-Slot
(see Table 10 on page 26). For the communication port, use only
the serial cable supplied in the P33 accessory kit.
If your rack has conductors for grounding or bonding of ungrounded
metal parts, connect the ground cable (not included) to the ground
bonding screw.
16A, IEC 320-C20
Communication Port Input Connector
Bay
REPO Port
Battery Connector
If an emergency power-off (disconnect) switch is required by local
codes, see the following section, "Remote Emergency Power-off
Installation" to install the REPO switch before powering on the
UPS.
Continue to "Power Connections and Startup" on page 9.
5125 (9910-P33) UPS Installation Guide for IBM
IEC 320-C13 Receptacles
IEC 320-C19 Receptacle
Figure 7. UPS Rear View
® S
Applications 164201634 Rev A
INSTALLATION
®
card
Circuit
Breakers
7