Setup And Installation; Tools Required - Eaton 9910-P33 Installationsanleitung

INSTALLATION
4.

Setup and Installation

The P33 UPS can be purchased separately or factory-installed in an IBM
iSeries or pSeries rack.
NOTE If the UPS is pre-installed in an IBM pSeries (RS/6000) system, continue to "EBM
Installation" on page 6 or "UPS Installation" on page 7.

Tools Required

To assemble the components, the following tools may be needed:
S
S
4
EATON Powerware
Figure 2. Connecting the Internal Battery Connector
Install the UPS front cover (see Figure 3).
Figure 3. Installing the Front Cover
Medium flat-bladed screwdriver
#2 Phillips screwdriver
®
5125 (9910-P33) UPS Installation Guide for IBM
® S
Applications 164201634 Rev A