Werbung
Verfügbare Sprachen
Verfügbare Sprachen
English
Safety guidelines to read before installing the product
1 The product must be used indoors only.
1 Do not place the product near liqu i d or In an excesslvel1• damp environment.
1 Do not place the product directly in the sun or near a heat sour
1 Do not let liquid or foreign objects enter the product.
1 Ground the product us i ng a 2P + ground socket.
1 When installing th8 product, ensure that the sum of the leakage currents of the product and the devices lt
supplies does not exceed 3.5 mA.
1 The AC-power Input must be connected to an approprlate
(fuse or circuit-breaker).
Warning; for safety reasons, only the 16A/16A lead should be used to connect the
HotSwap MBP (Maintenance Bypass) module to a UPS with a power rating greater than
2kVA.
Use
The
HotSwap MBP
connected loads
(Ho!Swap
Installation
Refer to the UPS installalion and user manual.
HotSwap MBP module operation
The
HotSwap MBP
1 Normal - the load is supplled by the UPS,
1 Bypass•
the load is supplied directly by the AC-power source.
UPS start-up with the HotSwap MBP module
1 - Check that the UPS is correctly connected to the
2 - Set swltch to the Norma l position.
3 - Start the UPS by presSlng the ON/OFF button on the UPS contml panel:
1 The load is supplied by the UPS.
1
Green LED "UPS ON -OK to switch" on the
HotSwap MBP module test
1 - Set swijch to the Bypass posilion and check that the load is still supplied.
2 - Set swltch back to lhe Nomial position.
Maintenance on a UPS equipped with the HotSwap
The
HotSwap MBP
connecled loads
(HotSwap
Maintenance:
1 - Set sw i tch to the Bypass position. The red LED on the
the load is supplied directly with AC power.
2 - Stop the UPS: green LED "UPS ON - OK to switch" goes OFF, the UPS can now be disronnected and
replaced.
Return to normal operation:
1 - Check that lhe UPS is correctly connected to the HotSwap
2 - Start the UPS: green LED "UPS ON -OK to switch' on the HotSwap MBPmodulegoesON (otherwise,
there is a connectlon error between the HotSWap MBP module and the UPS).
3 - Sat swijch to tha Norma l position. The red LED on the HotSwap MBP module goes OFF.
module makes it possible to Service or even replace the UPS without aflecting the
functlon).
module has a rotary switch with two positions:
HotSwap MBP
HotSwap MBP
module makes it posslble to service or even replace the UPS without aflectlng the
funclion).
HotSwap MBP
Informationen und Angebote auch auf www.edelstrom.eu
c
e.
electrical
network protectlon or tap-off clrcult
module.
module goes ON.
MBP
module
module goes ON, indicating that
MBP
module.
Werbung
