Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Additional safety rules for compound mitre saws
•
Never use cracked or damaged saw blades.
•
Replace the kerf plate when it is worn.
•
Use only saw blades recommended by the manufacturer.
•
Never use blades made of high speed steel (HSS).
•
Select the correct blade for the material to be cut.
•
Never saw material other than that for which the saw blade is intended.
•
Observe the maximum speed marked on the saw blade.
•
When moving the mitre saw, hold it by the handle.
•
Do not operate the machine without the guard in position, or if the guard does not
function or is not maintained properly.
•
Keep the surrounding work area free of loose chips and offcuts.
•
Use only those spacers and spindle adaptors approved for your saw.
•
If the saw is fitted with a laser, it must not be replaced by a different type. If damaged,
have the laser repaired by the manufacturer or an authorised repair agent.
•
Do not remove any offcuts or jammed material from around the blade area until
the blade has stopped.
•
Before sawing, make sure that the saw is stable and secure. When possible,
always mount the machine to a bench.
•
When sawing, always secure the workpiece using clamps or a vice if possible.
•
Use a table, roller stand, or similar to support long workpieces.
In spite of the application of the relevant safety rules and the implementation of
safety devices, certain residual risks cannot be avoided. The following hazards
are inherent to the use of mitre saws:
•
Contact with uncovered parts of the rotating saw blade.
•
Contact with rotating saw blade (cuts).
•
Workpiece or parts of it can be ejected back towards the user (kickback).
•
Shattered saw blade.
•
Flying metal particles if the carbide tips break off.
•
Impairment of hearing if ear defenders are not worn.
•
Health hazards caused by breathing dust in poorly ventilated work areas.
5
Werbung
Inhaltsverzeichnis
