Cocraft HMS 210-L Bedienungsanleitung Seite 4

• Firmly secure the workpiece. If possible use vices or clamps to hold
the workpiece in place. This is much safer than holding the workpiece in one hand.
• Do not overreach. Make sure that you stand steady and balanced all times.
• Look after your tools. Make sure that they are clean and that the edges are
sharp for maximum effect and best results. Follow the manual's recommendations
regarding lubrication and replacement of accessories.
• Inspect the mains lead regularly. If it is damaged it should be replaced by
a qualified service technician. Inspect all leads and cables regularly to check for
any damage. Make sure that the machine's handles and controls are clean, dry
and free from oil and grease.
• Turn the power off. Pull out the plug and push in the emergency stop button
before servicing or changing any blades, drill bits, cutters or sanding discs.
• Remove all spanners and repair tools. Make a habit of checking to make sure
that the machine is free of all spanners and tools before turning the power on.
• Avoid accidental starts. Do not walk around with your finger on the trigger of
a power tool if it is plugged in. Make sure that the on/off switch is set to OFF
before plugging in any power tool.
• Use the correct extension leads. If you use extension leads outdoors, only
use those designed for outdoor use. Only use extension leads with thick enough
diameter core wires and roll out the whole lead.
• Use common sense and be careful. Think before carrying out any task, so that
it is carried out safely. Never operate machines/power tools when you are tired or
under the influence of medicine.
• Check the following before turning the tool on:
- That all guards and other parts are whole and in working order.
- That moving parts are free and correctly aligned.
- That no moving parts can get caught.
- That there are no visible defects.
- Other factors that can influence work execution.
• Use only recommended accessories. The use of non-recommended
accessories can cause accidents and personal injury.
• Should only be repaired by a qualified technician. This tool conforms to current
safety requirements. Repairs to the tool should only be carried out by a tradesman
using original spares; otherwise the tool could cause accidents and personal injury.
4