Cocraft HMS 210-L Bedienungsanleitung Seite 10

Bevel cutting 0–45°
1. Undo the locking knob (31) and tilt the blade
to the desired angle with the help of the bevel
angle scale (3).
2. Tighten the locking knob to lock the bevel angle.
Adjust the fence (see below fig.).
3. Cut as described above.
Important:
When sawing with the blade tilted at an angle, the fence must be moved out of the way
to prevent it from obstructing the blade.
Fine-adjusting the 0° and 45° bevel angle stops
1. Undo the locking knob (31) and angle the saw to 0°.
2. Check the angle between the blade and the turntable using a 90° angle guide.
3. Adjust the end stop using the adjuster screw (30) by slackening the nut and turning
the screw. Lock the screw again afterwards by re-tightening the nut.
4. To adjust the 45° end stop, do as above but use the other adjuster screw (32) and
a 45° angle guide.
Mitre cutting -45°/0°/+45°
1. Raise the saw head (7) to its upper position by
releasing the lock (23).
2. Undo the mitre angle lock (11) and set
the saw to the desired mitre angle using
the scale (18).
3. Tighten the mitre angle lock and perform
cutting operations as described above.
20
40
60 80
10
20
40
60 80