Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Pic.2 – The water tank
Pic.3 – Continuous drainage
Pic.5 – The air filter
Pic.4 – The control panel
28
Condensate collecting tank
The tank is fitted with a floating device that stops the dehumidifier when the
tank is full.
How to empty the tank
Take out the tank as shown on Pic.2 . Use the sliding open (L) on the top of the
tank to flow the water out. Finally put the tank back into his place.
Continuous drainage
The tank is ready to fit the continuous drainage: the installation is very simple
and then you will not need to empty the tank manually anymore. To install the
continuous drainage follow these instructions (Pic.3):
• Remove the rubber stopper (T).
• Connect a rubber hose with an internal diameter of 10 millimeters to the
connector to the tank and run it through the hole F on the bottom of the
dehumidifier.
• Put the tank back into his place.
E
WARNING: to guarantee regular drainage of the water, make sure
that the drainpipe has a slope and is straight, without any bends or
constrictions. On any case the floating device inside the tank is active
and will stop the dehumidifier when full.
The air filter
The air is placed behind the rear grid and can be easily removed for cleaning.
The air filter can be cleaned with a vacuum cleaner or with water: in this case
dry it before assembly.
C
Do not run the dehumidifier without the air filter to avoid accumulat-
ing dust on the heat exchanger. Keep clean the air filter in particular
when al lot of dust is present in the air: a dirty air filter reduces the air
flow and the efficiency of the dehumidifier.
How to remove the air filter
Pull the front grid upward (see Pic.4): the air filter is behind the grid.
How to put the air filter on
Apply the air filter to the dehumidifier, then place the grid inserting first the up-
per side and then the lower side
The control panel
S1 - Green light ON The green light indicates when the dehumidifier is opera-
tive, otherwise it blinks on status 0.
S2 - Red light, full tank The light blinks, together with the green one S1, when
the tank is full, missing or incorrectly positioned.
S3 - Yellow light, defrost The light switches on during the automatic defrosting
cycle.
T1 - Decrease button Pushing this button the value of the display D will de-
crease down to 0 value.
T2 - Increase button Pushing this button the value of the display D will in-
crease up to C value.
D - Display The display shows the working state of the dehumidifier according
Dehumidifier
E N G L I S H
M 1 2 8 2 - 0
Werbung
Inhaltsverzeichnis
