Operation; Handling - MC Crypt Mercury Bedienungsanleitung

Operation

• You can activate/deactivate the colour change function with the switch on the back of the casing:
Position 0: colour change deactivated
Position I: Colour change activated
• Set the focus of the light effect with the two knurled screws on the top of the casing. To do so, loosen the two
screws and shift the lens support in the oblong holes until the effect is sharply focused on the projection surface.
• Then tighten the two knurled screws again when you have completed your settings.

Handling

• Never operate the device without casing!
• Never switch the effect beamer on and off at short intervals. This will reduce the working life of the illuminant
considerably.
• The device is not suitable for continuous use. Pauses in operation increase the working life of the product.
• Never plug the power plug into a mains socket immediately after the device was taken from a cold to a warm
environment. The condensation water created thereby may damage the device. Allow the device to reach room
temperature before connecting it. Wait until the condensation water has evaporated.
• Never touch the mains plug when your hands are wet.
• Never pull the mains plug by pulling the cable from the socket. Always only use the thus provided grip area.
• Remove the mains plug from the electrical outlet if the device is not in use for a longer period of time.
• For safety reasons always pull the mains plug from the socket during a thunderstorm.
• To ensure sufficient ventilation, do not cover the device. Apart from this, the air circulation may not be obstructed
by objects such as magazines, table cloths, curtains or similar. While the device is in operation, keep a free space
of at least 0.5m around the device.
19